Enterasys SecureStack A2 A2H124-48P Installation Guide download pdf (Page 46)

Connecting to Console Port for Local Management

3-16 Hardware Installation

Connecting to an IBM or Compatible Device

ToconnectanIBMPCorcompatibledevice,runningtheVTterminalemulation,toan

EnterasysswitchConsoleport(Figure 3‐9),proceedasfollows:

1. ConnecttheDB9femaleconnectoratoneendofthecable(notsupplied)tothe

ConsoleportontheEnterasysswitch.(Ifthereisaswitch

designatedastheManager,

connecttoitsConsoleport.)

2. PlugtheDB9femaleconnectorattheotherendofcableintothecommunicationsport

onthePC.

3. TurnonthePCandconfigureyourVTemulationpackagewiththefollowing

parameters:

Whentheseparametersareset,theStartupscreenwilldisplay.Proceed

to“Connectingto

theNetwork”onpage 3‐19.

Figure 3-9 Connecting an IBM PC or Compatible

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit

1 DB9 female connector 4 DB9 female connector

2 Serial interface cable 5 PC with VT emulation application

3 DB9 male Console port connector

Console

ÂÃ

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 81 82

No comments

Enterasys SecureStack A2 A2H124-48P Installation Guide Page 46