Enterasys Matrix N3 Installation Guide download pdf (Page 36)

Setting Up the Chassis

3-8 Chassis Setup

After completing the power supply and module installations, the chassis is ready to be powered up.

Proceed to Section 3.2.6 for instructions to power up the chassis.

3.2.6 Removing a Power Supply

To remove a 7C203-1 power supply, refer to Section 3.2.5 and proceed as follows:

1. Attach the anti-static wrist strap as described in Section 3.2.4 before handling the power supply

module.

2. Set the power supply 0/| Power switch to 0.

3. Unplug the power cord from the dedicated 15A/120 Vac outlet.

4. Unplug the power cord from the ac power socket of the power supply.

5. Unscrew the two captive slotted-head screws to release the power supply from the chassis.

6. To remove the power supply from the chassis, pull the power supply straight out of the chassis

and place it on an antistatic surface on in an antistatic bag for future use.

Caution: Always set the 0/| power switch to 0 before removing a power supply from the chassis.

Precaución: Antes de quitar la fuente de poder del chasis, coloque el interruptor 0/| en la

posición 0.

Caution: If you plan to operate the chassis with only one power supply, make sure to install a

coverplate in place of the removed power supply to contain EMI radiation.

Precaución: Si desea trabajar sólo con una fuente de poder, no olvide colocar la tapa en el

compartimiento de la fuente de poder que haya eliminado, para reducir la interferencia

electromagnética.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

No comments

Enterasys Matrix N3 Installation Guide Page 36