Enterasys Matrix 7H4382-49 Installation Guide download pdf (Page 61)

Using LANVIEW

DFE-Platinum Series Hardware Installation Guide 4-3

3. PresstheGROUPSELECTbuttonagainformorethanonesecond.Thisreturnsthe

7H4385‐49tothedefaultstatusmodetomonitorRX(receive)andTX(transmit)

activity.

Table 4‐1describestheLEDindicationsandprovidesrecommendedactionsas

appropriate.

Note: The terms used in Tab l e 4- 1 indicate the following:

• Flashing indicates LED is flashing randomly.

• Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).

• Solid indicates a steady LED light. No pulsing.

• Alternating indicates LED is flashing in a steady rate other than 50% on, 50% off.

Table 4-1 LANVIEW LEDs

LED Color State Recommended Action

MGMT Off Off. This DFE module is NOT

the Management Module.

None.

Green Solid. This module is the

designated Management

Module.

None.

Amber Flashing. This is a

temporary indication that the

DFE module is saving data.

None.

CPU Off Power off. Ensure chassis has adequate power.

Amber Blinking. DFE module in

process of booting.

None.

Solid. Testing. If the LED remains amber for several

minutes, contact Enterasys Networks

for technical support.

Green Blinking. Image starts

running.

None.

Solid. Functional. None.

Red Solid. Processor in reset. None.

Green and

Amber

Blinking. Indicates that the

DFE module is in the process

of shutting down.

None. This state is activated when the

OFFLINE/RESET switch is pressed for

less than 1 second to start the process

of an orderly shutdown.

While in this state, do not remove any

DFE module.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 91 92

Comments to this Manuals

No comments

Enterasys Matrix 7H4382-49 Installation Guide Page 61

Comments to this Manuals

Related products and manuals for Network switches Enterasys Matrix 7H4382-49