Enterasys RBT-4102 Specifications download pdf (Page 36)

Initial Setup Using the CLI

3-10 Initial Configuration

c. SpecifyanewpasswordinthePasswordfield.

d. SpecifythenewpasswordagainintheConfirmPasswordfield.

e. ClickApplyatthebottomofthepage.

TheaccesspointdisplaysaSettingsSavedmessage.

f. ClickOK.

7. TospecifythemanagementVLANID:

a. ClickFilterControlfromthemenu.

TheFilterControlpageappears.

b. Click

theManage mentVLANID:fieldandentertheVLANIDfromwhichyouwill

managetheAP.

ThemanagementVLANisformanagingtheaccesspoint.Forexample,theaccesspoint

allowstrafficthatistaggedwiththespecifiedVLANtomanagetheaccesspointvia

remotemanagement,SSH,SNMP,

Telnet,andsoforth.VLANmanagementisenabledby

default,andcannotbedisabled.

c. ClickApplyatthebottomofthepage.

8. GotoChapter 4foradvancedconfiguration.

Note: You must set up the network switch port to support tagged VLAN packets from the

access point. The switch port must also be configured to accept the access point’s

management VLAN ID and native VLAN IDs.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 167 168

No comments

Enterasys RBT-4102 Specifications Page 36