Enterasys RBT-4102 Specifications download pdf (Page 80)

Administration

4-44 Advanced Configuration

Using the CLI to Upgrade Firmware

TodownloadsoftwarefromaTFTP/FTPServer,usethecopycommandfromtheExecutivemode.

Thecopycommandrequiresyoutospecifyeitherthefiletypeandthentheservertype,orthe

servertypeandthenthefiletype.Youmustthenspecifythefilename,andIPaddressof

theTFTP

server.Whenthedownloadiscomplete,youcanusethedircommandtocheckthatthenewfileis

presentintheaccesspointfilesystem.Torunthenewsoftware,usetheresetboardcommandto

reboottheaccesspoint.

Example

RoamAbout 4102#

RoamAbout 4102#copy tftp file

1. Application image

2. Config file

3. Boot block image

Select the type of download<1,2,3>: [1]:1

TFTP Source file name:ets-img_v1017.bin

TFTP Server IP:10.120.112.2

Firmware version of system is V1.0.16 and Updating Run-Time code v01.00.17 NOW!

This firmware is compatible with hardware.

The software was properly copied over to the system and a reset is needed in order

for the software changes to take place.

RoamAbout 4102#

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 167 168

No comments

Enterasys RBT-4102 Specifications Page 80