Enterasys Matrix N3 Installation Guide download pdf (Page 41)

Removing and Reinstalling the Fan Tray

Chassis Setup 3-13

3.4.2 Reinstalling the Fan Tray

To reinstall the fan tray, refer back to Figure 3-7 and proceed as follows:

1. Locate the ESD wrist strap shipped with the N3 chassis. Attach the ESD wrist strap to your wrist

and plug the cable from the ESD wrist strap into the ESD grounding receptacle at the front

upper-right corner of the chassis.

2. Hold the fan tray by its handles and align the four fan tray captive screws with the tapped holes

in the rear of the chassis.

3. Slide the fan tray into the chassis until the faceplate of the tray is flush with the rear of the N3

chassis. If there is strong resistance, remove the fan tray and reinsert it.

4. Once the tray is in place, tighten the four captive screws to secure the tray to the rear of the

chassis.

Caution: Although the fan tray has a self-aligning power connector that mates with the one in the

rear of the chassis, do not force the fan tray into place, as it may damage the chassis and fan tray.

Precaución: Aunque la bandeja cuenta con un conector de alimentación que se alinea

automáticamente con el que está en la parte trasera del chasis, no debe forzar la bandeja de

ventiladores en su lugar, ya que podría dañarla o dañar el chasis.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46

No comments

Enterasys Matrix N3 Installation Guide Page 41