Enterasys Matrix 7H4385-49 Installation Guide download pdf (Page 13)

DFE-Platinum Series Hardware Installation Guide xi

About This Guide

Thisguideprovidesanoverview,installationandtroubleshootinginstructions,andspecifications

fortheEnterasysMatrix

DFE‐Platinum7G4202‐72and7G 4282‐49modules.

ForinformationabouttheCLI(CommandLineInterface)setofcommandsusedtoconfigureand

managetheDFEmodules,refertotheEnterasysMatrixDFE‐PlatinumSeriesConfigurationGuide.

Who Should Use This Guide

Thisguideisintendedforanetworkadministratorresponsiblefor installingandsettingupthe

DFEmodules.

Note: In this guide, the following terms are used:

• DFE refers to Distributed Forwarding Engine series of modules.

• DFE module or module refers to both the 7G4202-72 and 7G4282-49 modules. If the information

applies to only one of the modules, the module is referred to by its model number (such as

7G4282-49).

• Network expansion module or NEM refers to an optional uplink card installed on the main logic

board and accessible through the option slot of the 7G4282-49.

Important Notice

Depending on the firmware version used in the DFE module, some features described in this document may

not be supported. Refer to the Release Notes shipped with the DFE module to determine which features are

supported.

Electrical Hazard: Only qualified personnel should perform installation procedures.

Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.

Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes

Personal vorgenommen werden.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 65 66

No comments

Enterasys Matrix 7H4385-49 Installation Guide Page 13