Installing Module into Matrix E7 or Matrix N7 Chassis
DFE-Platinum Series Hardware Installation Guide 3-5
Installing Module into Matrix E7 or Matrix N7 Chassis
ToinstallaDFE‐PlatinummoduleintoaMatrix E7orMatrix N7 chassis,proceeddirectlyto
“Preparation”onpage 3‐5tostarttheinstallationprocess.
Preparation
1. Removetheblankpanelcoveringtheslotinwhichthemodulewillbeinstalled.Allotherslots
mustremaincoveredtoensureproperairflowforcooling.(Savetheblankplateintheevent
youneedtoremovethemodule.)
2. Removethemodulefromtheshippingbox.(Savetheboxandpacking
materialsintheevent
themoduleneedstobereshipped.)
3. Locatetheantistaticwriststrapshippedwiththechassis.Attachtheantistatic wriststrapto
yourwristandplugthecablefromtheantistaticwriststrapintotheESDgroundingreceptacle
attheupperrightcornerofthechassis.
4. Removethemodule
fromtheplasticbag.(Savethebagintheeventthemodulemustbe
reshipped.)ObserveallprecautionstopreventdamagefromElectrostaticDischarge(ESD).
5. Examinethemodulefordamage.Ifanydamageexists,DONOTinstallthemodule.
ImmediatelycontactEnterasys Networks.Referto“GettingHelp”onpage xiii.
Caution: Failure to observe static safety precautions could cause damage to the DFE module.
Follow static safety handling rules and wear the antistatic wrist strap.
Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or
components can cause damage.
Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de
electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la
manipulación del producto y no olvide utilizar la pulsera antiestática.
No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante
entra en contacto con la placa o con los componentes, éstos podrían dañarse.
Comments to this Manuals